50A Clamp for Shelly EM
£14.79
This 50A current clamp is a sensor for the original Shelly EM energy meter, rated for a 50A primary current with 1% accuracy using a ferrite core design. It is compatible with the Shelly EM only — the manufacturer explicitly notes it will not work with the Shelly EM Gen3.
- Rated for 50A primary current, 1% accuracy
- Ferrite core clamp construction
- Compatible with original Shelly EM only, not EM Gen3
- Electrical strength rated to 3000VAC for safe isolation
Buy the 50A Clamp for Shelly EM online in the UK from ShellyUK — genuine Shelly stock with fast UK delivery.
Compatible with Shelly EM only.
*NOT COMPATIBLE WITH SHELLY EM GEN3
Rated for 50A primary current, 1% accuracy
Ferrite core clamp construction
Compatible with original Shelly EM only, not EM Gen3
Electrical strength rated to 3000VAC for safe isolation
Where you'd use it
Original Shelly EM Spare
Keep one as a spare or replacement clamp for an existing original Shelly EM installation, since it's not compatible with the Gen3 version.
Legacy Installation Expansion
Add a second monitored circuit to an older Shelly EM setup that's already in service, using its unused second channel.
Circuit-Specific Metering
Clamp it around a single circuit rated up to 50A, such as a shower or oven feed, to isolate its consumption from the rest of the board on an existing EM.
Specification
Physical & Build
- Compatible devices • Shelly EM
Other
- Accuracy
- 1%
- Core Ferrite core
- Electrical Strength
- 3000VAC 1mA60s
- Internal diameter
- 10mm
- Load Resistance
- 20Ω
- Rated Primary Current
- 50A
- Rated Secondary Current
- 16.67mA
- Saturation current ≥ 85A
Reviews
There are no reviews yet.