50A Clamp for Shelly EM Pro/Gen3
£14.79
This 50A current clamp is the sensor for the Shelly Pro EM and Shelly EM Gen3, rated for a 50A primary current with 1% accuracy. It uses a ferrite core design and is intended specifically for these two Shelly meters rather than the original Shelly EM.
- Rated for 50A primary current, 1% accuracy
- Ferrite core clamp design
- Compatible with Shelly Pro EM and Shelly EM Gen3 only
- 10mm internal core diameter for standard cable runs
Buy the 50A Clamp for Shelly EM Pro/Gen3 online in the UK from ShellyUK — genuine Shelly stock with fast UK delivery.
Compatible with Shelly Pro EM & Shelly EM Gen3.
Rated for 50A primary current, 1% accuracy
Ferrite core clamp design
Compatible with Shelly Pro EM and Shelly EM Gen3 only
10mm internal core diameter for standard cable runs
Where you'd use it
Third-Channel Expansion
Add a spare clamp to a Shelly Pro EM or EM Gen3 installation to bring a second circuit, such as a solar diversion feed, into monitoring alongside the main incomer.
Replacing a Damaged Clamp
Swap out a clamp that's been damaged during a rewire or panel change without needing to replace the whole EM Gen3 or Pro EM unit.
Dedicated Circuit Tracking
Fit it around a single sub-circuit, such as an EV charger or heat pump feed rated up to 50A, to isolate its consumption from the rest of the board.
Specification
Physical & Build
- Compatible devices • Shelly EM • Shelly Pro EM
- - 50A • Shelly EM Gen3
Other
- Accuracy
- 1%
- Core Ferrite core
- Electrical Strength
- 3000VAC 1mA60s
- Internal diameter
- 10mm
- Load Resistance
- 20Ω
- Rated Primary Current
- 50A
- Rated Secondary Current
- 16.67mA
- Saturation current ≥ 85A
Reviews
There are no reviews yet.